Update 02
After discussing with my team, my plan for the coming week is to further design the casing and measurement selection for the multimeter. This will continue to be done in Onshape same as the dial design done this week. On top of that I will continue growing my related skills, this time particularly in KeyCad. The hour long tutorial video I followed this week was a great starting point, and I hope to find more like it.

Update 04
With CDR being the primary focus, I completed the main body of the multimeter as well as started working on the stand. For the week of 02/17, I hope to complete the switching mechanism by ordering contacts, start importing some of the set dimensions we have for parts, and have a completed case printed.
Update 05

With the PCB being finalized and being prepared to being order, I have started incorporating the dimensions into the case design. The above picture shows the inside of the bottom half of the case as well as the snap on stand. The rest of this week will be spent on making two copies, one for the rechargeable battery and another for the 9 volt, as well as adding the contacts to the dial and any more last minute touches.
Update 08
This week has been a little lax in work done due to the boards just having been ordered. Once the boards arrive, I will print and double check the sizing for the case, as well as assist with the soldering when I have time. My teammates have done a wonderful job and have test code up and running, so I am very excited to see that in action as well.